RIPAlcatel

Un article de IPv6.

Routage Statique Cisco Table des matières RIP Cisco
-> # Charge le module RIP et l'active sur le switch
-> ipv6 load rip
-> ipv6 rip status enable
-> # Démarre RIP sur l'interface virtuelle monReseau
-> ipv6 rip interface monReseau2
-> show ipv6 routes
Legend: Flags: U = Up, G = Gateway, H = Host, S = Static, C = Cloneable, D = Dynamic,
M = Modified, R = Unreachable, X = Externally resolved, B = Discard,
L = Link-layer, 1 = Protocol specific, 2 = Protocol specific
Destination Prefix    Gateway Address           Interface  Age        Protocol Flags
---------------------+-------------------------+----------+----------+--------+-------
::1/128               ::1                       loopback   0h 13m 18s Local    UH
2001:660:3208:1::/64  2001:660:3208:2::1        monReseau2 0h  0m  5s Static   UGS
2001:660:3208:2::/64  fe80::2d0:95ff:fe93:c681  monReseau2 0h  5m 27s Local    UC
2001:660:3208:3::/64  fe80::260:97ff:fe0c:dcbf  monReseau2 0h  0m 31s RIP      UGD
fe80::/64             fe80::2d0:95ff:fe93:c681  monReseau2 0h  6m 50s Local    UC
fe80::/64             ::1                       loopback   0h 13m 18s Local    U
ff01::/32             ::1                       loopback   0h 13m 18s Local    U
ff02::/32             fe80::2d0:95ff:fe93:c681  monReseau2 0h  6m 50s Local    UC
ff02::/32             ::1                       loopback   0h 13m 18s Local    UC
->

Routage Statique Cisco Table des matières RIP Cisco
HOME